Additional Information on the VX20W Wagon Vise

I have received many comments and questions about our new wagon vise. This might turn out to be our most popular vise! The dog block for the VX20W vise mechanism simply bolts to the side with four 1/4″ diameter hex head cap screws that are counter-bored into the dog block.

VX20W Dog Block Mounting

It is designed for a 1-3/4″ thick dog block but a thinner dog block may be used if you substitute shorter bolts (the dog block pictured is 1-3/8″ thick). A dog block thicker than 1-3/4′ simply requires deeper counter-bored holes. The dog block may use round dogs or it can be made to accept a rectangular dog.

VX20W Installed

When I make new vises I always test them in a small test bench before I put them in an actual bench. This makes it much easier to check the operation and make changes if necessary. I made this test bench out of construction grade lumber which I air dried in my shop for a couple of weeks before milling it. The above picture shows how the vise mounts in a cavity in the bottom of the bench. The dog block protrudes into the slot on the right. For best performance the bench top cavity should reduce the bench top thickness to about 2″ in the area where the vise operates.

VX20W Rear Bearing Bracket Mounted

The rear bearing mounts to the bottom of the benchtop using this stout bracket. The hole in the bracket allows the slot length to be customized to a shorter length as desired by allowing the shaft to protrude through.

VX20W End Cap Bearing & Collar

A Delrin bearing screwed to the end cap supports the front of the shaft. The extra large shaft collar and thrust bearings transmit the load. With the VX20W you will have the option of a wooden hub and handle or a small 5″ diameter metal hand wheel that matches the large 8″ metal hand wheel used with the face and leg vises. I don’t yet have the small hand wheel up on the website but I hope to have it done soon.

VX20W With Dog BlockVX20W End Cap View

 

Say Hello To The New VX20W Wagon Vise

019

We are really excited to show the first images of the new VX20W quick action wagon vise. I wish this new vise was not hidden under the bench because I think it looks pretty cool! We have made a lot of refinements and improvements with this new vise. The housing is very small and is totally enclosed to keep the sawdust out.

016

The four bolts protruding from the side of the housing are used to mount the wooden dog block to the housing. The dog block will then extend up to bench top height through a slot.

This vise will be very easy to install. The rear of the shaft will ride in a delrin bearing mounted to the bottom of the bench top with a sturdy bracket.

009

The front of the shaft is supported with a Delrin bearing mounted to the outside of the bench end cap. The shaft protrudes through this bearing and your choice of metal hand wheel or wooden hub and handle will ride against this bearing.

024

The thrust load of the vise is transmitted into the end cap through a heavy duty thrust collar and large bronze thrust bearing. The thrust bearing is oil impregnated to provide low friction operation.

008

I hope to have an installation video of the VX20W completed soon so you can see how it will all go together and operate.